ProPowders™
The next generation
of powdered nutrients
ProPowders™
The next generation
of powdered nutrients
The first powdered nutrient with true organics.
Commercial powdered nutrients have always been mineral-only. There’s a reason for that. Raw organics clump, foam, destabilise and block drippers — they simply don’t survive the format. Dry them into a powder and the problem multiplies. This means that powder manufacturers leave organics out entirely, and growers are forced to accept a mineral-only feed. So we rebuilt them.
What’s left is a stable, fully soluble, and nutrition dense formula. Which is why ProPowders™ are the first powdered nutrients to carry true organics.
01 — We identify the bioactive molecules within a raw organic compound that are beneficial for plant nutrition
02 — We isolate and purify these bioactive molecules removing every ‘nuisance compound’
03 — We adjust the concentration of these purified molecules to the optimal level at which the plant performs at
What extracted organics actually do
Minerals feed a plant. Organics change how it grows.
Structure and Stacking
Bioactive molecules alter the plant's physical architecture — more branching, more bud sites, tighter stacking.
Roots and Uptake
A stronger, larger root mass improves access to nutrients, enabling faster uptake and more vigorous growth.
Resin and Flavour
Bioactives trigger secondary metabolite production — terpenes, flavonoids, cannabinoids and esters. This is where the aroma and flavour of the finished crop are decided.
Solubility
With the nuisance compounds removed, ProPowders™ dissolve fully in minutes — even in cold or hard water. Warm RO water is not required. High solubility also helps keep drippers clean and simplifies clean-up.
ProPowder™
Product Range
Dosing Options
Add directly to reservoir
STEP 1 — Use Dosage Charts ProPowders™ to calculate and weigh out out each powder
STEP 2 — Add the dry powder directly into the reservoir
✓ Dissolves within minutes
✓ Suitable for drippers
✓ Dissolves in cold or hard water
Create stock solutions
STEP 1 — Use the ProPowder™ Usage Estimator to calculate and weigh out each powder
STEP 2 — Mix each powder with sufficient water to create a liquid stock solution (eg. 1L of Veg-1 stock contains 215g of Veg-1 powder). Then Dose according to Dosage Charts Liquids
✓ Stable for 6+ months
Create dry pre-mixes
STEP 1 — Use the Dosage Charts ProPowders™ to calculate and weigh out out each powder required for a single dosing batch
STEP 2 — Combine each powder into an air-tight container away from direct sunlight, preferably below 25oC (77oF) and store until required. Allocate entire pre-mix to one nutrient batch.
✓ Batch prep is centralized
✓ Reduces human dosing errors
✓ Avoids recipe theft
EXAMPLE: To create a dry pre-mix for ‘Vegetative Week-1’, combine the doses for Veg-1, Root-XS and OrganaBud
ProPowder™ 'Dry Pre-Mix' makes dosing so easy
ProPowders are extremely easy to use especially when dosing dry to reservoir as a 'dry pre-mix'.
01
Equipment
Start with a suitable* set of scales, a measuring cup and an air-tight jar. Place the measuring cup on the scales then “tare” (or zero) it off.
02
Calculate
Refer to the feed chart and determine the required weight of each product for the reservoir size. For example, Veg-1 Wk-1 for 100L reservoir requires 110g.
03
Measure
Carefully measure out the Veg-1 dose then dump this into the jar. Repeat this step with the remaining ProPowder additives until the jar contains a “dry pre-mix” customised for the week and reservoir volume.
04
Mix
Tip this dry pre-mix into the reservoir and activate the mixing pump until fully dissolved. Add any other required additives then check and adjust pH. If the dry pre-mix is not being used immediately, ensure it is kept tightly sealed and labelled appropriately eg. Veg-1 Wk-1 (100L Res).
100% Soluble
Within Minutes
ProPowder™ stock solutions will dissolve in cold or hard water within minutes. High solubility reduces blockages, clean-up and the need for warm RO water. Stock is stable for at least 6 months, which is ideal for auto-dosers and drippers.
What's the Simplest Way to Use ProPowders™ ?
ProPowders are extremely easy to use especially when dosing dry to reservoir as a 'dry pre-mix'.
1
Equipment
Start with a suitable* set of scales, a measuring cup and an air-tight container. Place the measuring cup on the scales then “tare” (or zero) it off.
2
Calculate
Refer to the feed chart and determine the required weight of each product for the reservoir size. For example, Veg-1 Wk-1 for 100L reservoir requires 110g.
3
Measure
Carefully measure out the Veg-1 dose then dump this into the container. Repeat this step with the remaining ProPowder additives until the container contains a “dry pre-mix” customised for the week and reservoir volume.
4
Mix
Tip this dry pre-mix into the reservoir and activate the mixing pump until fully dissolved. Add any other required additives then check and adjust pH. If the dry pre-mix is not being used immediately, ensure it is kept tightly sealed and labelled appropriately eg. Veg-1 Wk-1 (100L Res).
ProPowders™ FAQ's & Directions
What's the Simplest Way to Use ProPowders™ ?
ProPowders are extremely easy to use especially when dosing dry to reservoir as a 'dry pre-mix'.
Equipment
Start with a suitable* set of scales, a measuring cup and an air-tight container. Place the measuring cup on the scales then “tare” (or zero) it off.
Calculate
Refer to the feed chart and determine the required weight of each product for the reservoir size. For example, Veg-1 Wk-1 for 100L reservoir requires 110g.
Measure
Carefully measure out the Veg-1 dose then dump this into the container. Repeat this step with the remaining ProPowder additives until the container contains a “dry pre-mix” customised for the week and reservoir volume.
Mix
Tip this dry pre-mix into the reservoir and activate the mixing pump until fully dissolved. Add any other required additives then check and adjust pH. If the dry pre-mix is not being used immediately, ensure it is kept tightly sealed and labelled appropriately eg. Veg-1 Wk-1 (100L Res).
Do ProPowders™ outperform liquid nutrients?
How easily do ProPowders™ dissolve?
ProPowders™ are highly soluble compared to many powder formulations. In fact, they remain highly soluble even in hard, cold water – see chart below. They do NOT require RO water or warm water.
How much nutrient do the ProPowders™ make?
The weight of ProPowder™ bags are configured to create a specific volume of stock concentrate. For example, the Veg-1, 215g bag makes 1L of liquid stock (stock concentrate), or 180L of nutrient solution (working nutrient).
How do I dose with ProPowder™ ?
- Add dry powder directly to the reservoir, either individually or as a dry pre-mix. See Dose Chart ProPowders™.
- Stock Concentrate made from the powder – See Dose Chart Liquids. Dosing can be done manually or via auto-dosers
Is there a ProPowder™ Kit, or Starter Kit?
There are two ProPowder™ Kits. These are compact and light and can be air-freighted to most destinations within 1-2 weeks.
Both kits are configured for 4-weeks of veg and 8-weeks of flower. They contain Veg-1 and the 4-core additives (Root-XS, OrganaBud, Flowering Enhancer and Resin-XS).
- 5-Plant Kit : Produces 65L (17 Gal) of working nutrient per week e.g. Feeds 5 x 10L coco pots with 1.9L per day.
- 20-Plant Kit : Produces 265L (70 Gal) of working nutrient per week e.g. Feeds 20 x 10L coco pots with 1.9L per day.
Can I use a part-bag of ProPowder™, or does a whole bag need to be used?
ProPowders™ are ‘homogenous’ which enables part bags to be used without affecting plant performance or reservoir stability.
What type of weighing scale do I need to use?
Measure powder dose rates using weight scales. Measuring by volume (ml or tsp) is inaccurate.
For reservoirs ranging from 10L–1,000L, the optimum scales are 3kg with a resolution of +/- 0.1g ie. typically termed 3kg x 0.1g.
What is the shelf-life of liquid stock made from ProPowder™?
Liquid stock generally lasts 6 months or longer. For best results, add 1ml/L System Maintenance and store below 25°C (77°F) in dark or opaque containers away from direct sunlight.
Can I combine the FloraMax liquid version and ProPowder™ in the same reservoir?
Yes, liquid and powder can be used interchangeably. For dose rates, simply refer to the corresponding dose chart. For example, if using the FloraMax liquid dose chart, but want to use Resin-XS ‘powder’’, simply replace the Resin-XS liquid rates with those from the FloraMax ProPowder™ dose chart. Also, for a given product, you can dose using a combination of liquid version and powder in the same reservoir.
Can Stock Concentrate from ProPowder™ be blended ‘neat' with the equivalent FloraMax liquid version?
Do NOT combine a Stock Concentrate with the equivalent FloraMax liquid version when in concentrated form.
Why does the FloraMax liquid version have a different NPK than the powder?
The reason for the large difference between their NPK specification and Guaranteed Analysis is that the powder contains no water and is therefore more concentrated. This makes the powder far easier to transport and store.
